CB Low Temp Occupancy Sensor
- Passive Infrared occupancy sensor for areas of extreme low temperatures
- Adjustable digital sensitivity & time delay
- Contains an isolated relay contact for use with HVAC or other control systems
- Choice of 4 different coverage patterns
- UL and CUL Listed; Five year warranty
The Watt Stopper CB-100 passive infrared occupancy sensor was engineered for installation in cold and damp conditions including the outdoors. It uses electronic components specially selected to allow for reliable operation in extreme temperature and environmental conditions. The CB-100 can operate in areas with temperatures as low as -40°F.
The CB-100 operates on 24 VDC and controls lighting through Watt Stopper power packs. It is equipped with a swivel mount bracket for convenient installation. The unit detects occupancy and turns lighting on when it senses a change in infrared heat radiated within the controlled area. After the area is vacated and after a user-adjustable time delay, lighting automatically turns off.
The CB-100 features a gasketted, watertight enclosure which prevents moisture and dust from entering the sensor and affecting occupancy detection. The sensor uses a DIP switch for time delay and unit sensitivity adjustments. Time delay can be set at 15 seconds, 5 minutes or 10 minutes and the unit sensitivity has 4 settings ranging from minimum to maximum. To help achieve the best possible coverage, the CB-100 is available with a choice of three different lens patterns. In addition, it contains a single-pole, double-throw isolated relay that can be used to interface with HVAC, EMS, monitoring systems, or with an additional lighting load. The isolated relay has normally open and normally closed outputs and is rated for 1 Amp at 24 VDC.
The CB-100 has been manufactured for the specification of lighting control in low temperature areas. With this sensor, areas such as cold storage rooms, freezers, and unconditioned spaces subject to extreme low temperatures can receive the same reliable lighting control and energy savings as other building areas. Using the isolated relay contact to interface with HVAC, EMS or other building control systems will also increase savings.
CB-100 temp range: -40°F(-40°C) to +95°F(+35°C) (The CB-100 can function at temperatures greater than 95°F but coverage may be reduced)
3.94" x 3.74" x 2.36" (100mm x 95mm x 60mm)
Red LED indicates motion detection
Digital time delay settings of 15 sec, 5 min, or 10 min